photos Show more

---

---

JeffTron Leviathan V2 Optical Drop-In MOSFET/Microcontroller Unit (Rear Wired) with with Flat MP5 Trigger

Leviathan - from JeffTron, not Hobbes

Leviathan Optical is one of the most advanced ETUs (Electronic Trigger Unit) on the market. The settings can be tinkered with via Bluetooth with basically any iOS or Android smart phone. Leviathan replaces the traditional trigger switch - no soldering needed! In general this bad boy gives you new features and upgrades the replica to a new level.

V2 gearbox version is supplied with aluminum adjustable CNC machined special trigger making it possible to adjust the trigger pull to only 0.13 mm! It is also possible to use the replica's original trigger with the unit, but this requires modifying the trigger. Fortunately, the manufacturer has very clear pictured instructions for this!

Note! V3 Leviathan does not come with a trigger, but by default the replica's standard trigger is used. However, there are hair trigger padding pieces (2x1 mm and 2x2 mm) delivered with the unit, that can be used to shorten the trigger pull.

Features:

• Fully adjustable fire modes, including SAFE.
  
• Three different burst fire modes. These are adjustable between 2 and 20 shots.
• Empty magazine detection.
• Rate of fire (RoF) can be limited down to -40% of the original
• Adjustable active brake. Can also be disabled completely.
• Spring precocking with semi. This makes shots practically instant.
• Optional delay between shots (Sniper Delay). The interval can be set between 0.1 to 4.0 seconds.
• Electronic fuse with adjustable sensitivity.
  
• Battery too low voltage indicator. This works with 2S-4S/7,4-14,8 V LiPo and 3S-4S / 9,9-13,2 V LiFe batteries.
• A virtual magazine mode to simulate a low/real cap magazine.
• Power connector for external accessories, like tracer units attached to hop-up.
• Comprehensive statistics available, like cycle timing, motor power consumption and rate of fire.
• The app shows the actual battery voltage in real time.
• The user can save several different configurations in different profiles.
• The operating system can be updated. Updates often fix issues and add new features to the unit.
• 3 different shot counters: the first counts all shots during the device's lifetime, the second can be reset by the user e.g. after maintenance, and the third is reset every time the battery is removed from the device.
• The error log shows the problems that have arisen during the use of the device.
• The wireless Bluetooth connection can be disabled. Security is the key!
• The device monitors the current, voltage and temperature of the unit, protecting itself from damage in possible failure situations.
• The programmed settings are saved in real time.

Installing and using:

• Installing the device inside a gearbox requires an understanding and knowledge of airsoft replica's inner workings - when in doubt, consult a professional.
• Read the user manual carefully before installing the Leviathan unit.
• A short circuit or incorrectly connected battery will break the unit immediately! Incorrect connection voids the warranty and can have fiery results with the battery!
• Always remove the battery from the replica when the replica is not in use! Otherwise, the unit will gradually drain your battery, in which case the battery may break. (When the battery is connected, Leviathan consumes the battery with a small current in stand by mode.)
• Always ensure the safe orientation of the barrel before connecting the battery!
• Do not modify or repair the Leviathan V2 circuit or expose it to liquids or heat.

MOSFET (Metal Oxide Semiconductor Field Effect Transistor)

The unit reduces power loss due to normal mechanical contact in the trigger switch. When using MOSFET only the signal current flows through the trigger switch and the actual running current goes directly from the battery to the motor. This prevents the burning of the trigger contacts, which is going to happen sooner or later, especially when using powerful batteries – the average lifetime for contact surfaces in an actively used gun is around one year. At the same time, the MOSFET unit enables the maximum power flow in the circuit without unnecessary resistance due to worn trigger contacts. This also gives you a higher rate of fire and a faster trigger response.